Filter
Top Products
6
4. With the help of a second person, lower the Uprights (11)
until the Left and Right Handrails (1, 88) are resting on
the floor. Attach the lower end of the Right Handrail (88)
to the Extension Leg (34) with a Handrail Bolt (91), a
Handrail Washer (92), and a Handrail Nut (47) as shown.
Note: It may be necessary to push on the lower end of
the Handrail to align the hole in the Handrail with the hole
in the Extension Leg.
Attach the Left Handrail to the left Extension Leg (not
shown) as described above.
Raise the Uprights (11) to the position shown in step 3.
4
47
92
91
88
11
34
6. Attach the Storage Latch (14) to the left Upright (11) with
two Screws (33). Be careful not to overtighten the
Screws.
Place the 3-lb. Weights (79) in the center slots of the
Weight Rack (90), the 2-lb. Weights (not shown) next,
and the 1-lb. Weights (not shown) in the outer slots.
7. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a
secure place. The allen wrench is used to adjust the walking belt (see page 13). To protect the floor or carpet,
place a mat under the treadmill.
33
14
11
79
90
6
5. Cut and remove the plastic tie on the right Upright (11).
Place the Console Base (46) on the Uprights (11) (only
the right Upright is shown). Wrap the cable tie around the
Wires (21) or pull the Wires through the cable tie loop.
Pull the cable tie tight and cut off the end of the cable tie.
Connect the two Wires (21) to the two connectors in the
Console Base (46). Important: Make sure that the
Wires are fully inserted. WARNING: Do not discon-
nect or connect the Wires while the treadmill power
cord is plugged in. Loosely thread four Screws (33) into
the Uprights and the Console Base. After all four Screws
have been started, tighten the Screws until they are
snug; do not overtighten the Screws.
33
Plastic Tie
Cable
Tie
21
Connectors
46
11
5
3. Attach the Weight Rack (90) to the Uprights (11) with the
two Rack Washers (41) and Rack Bolts (89). Note: If nec-
essary, spread the Uprights apart to align the holes in the
Weight Rack with the holes in the Upright.
Insert the Right Handrail (88) into the upper end of the
right Upright (11), with the lower end of the Handrail on
the side of the Extension Leg (34) as shown. Have a sec-
ond person hold the Right Handrail until step 4 is com-
pleted.
11
89
89
41
90
34
88
41
11
3