Filter
Top Products
7. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a
secure place. The allen wrench is used to adjust the walking belt (see page 13). To protect the floor or carpet,
place a mat under the treadmill.
6. Attach the Storage Latch (14) to the left Upright (11) with
two Small Screws (13). Be careful not to overtighten
the Screws.
Place the Weights on the Weight Rack (90) with the
3 lbs. Weights (79) in the center of the Rack and 2 lbs.
Weights next, followed by the 1 lbs. Weights.
13
14
11
79
90
6
5. Cut and remove the plastic tie holding the Wires (21).
Place the Console Base (46) on the right and left
Uprights (11) (only the right Upright is shown). Connect
the two indicated Wires (21) to the two connectors in the
Console Base. Important: Make sure the Wires are
fully inserted. WARNING: Do not disconnect or con-
nect the Wires while the treadmill power cord is
plugged in. Loosely thread four Screws (33) into the
Uprights and the Console Base. After all four Screws
have been started, tighten the Screws until they are
snug; do not overtighten the Screws.
Thread the Cable Tie (16) through the Clamp (61),
around the two Wires (21), and through the end on the
Cable Tie. Pull the Cable Tie tight and cut off the end.
33
Plastic Tie
Cable
Tie
21
Connectors
46
11
5
3. Attach the Weight Rack (90) to the Uprights (11) with the
two Rack Washers (41) and Rack Bolts (89). Note: If nec-
essary, spread the Uprights apart to align the holes in the
Weight Rack with the holes in the Upright.
Insert the Left and Right Handrails (1, 88) into the upper
end of the Uprights (11), with the lower end of each
Handrail to the outside of the Extension Leg (34) as
shown. Have a second person hold the Handrails until
step 4 is completed.
11
11
1
89
89
41
90
34
88
41
3
4. With the help of a second person, lower the Uprights (11)
until the Left and Right Handrails (1, 88) are resting on
the floor. Attach the lower end of the Right Handrail (88)
to the Extension Leg (34) with a Handrail Bolt (91),
Handrail Washer (92), and Handrail Nut (93) as shown.
Note: It may be necessary to push on the lower end of
the Handrail to align the hole in the Handrail with the hole
in the Extension Leg.
Attach the Left Handrail to the left Extension Leg (not
shown) as described above.
Raise the Uprights (11) to the position shown in step 3.
4
6
93
92
91
88
11
34