ProForm PFEL3226.0 Home Gym User Manual


 
10
HOW TO USE THE ELLIPTICAL EXERCISER
HOW TO MOVE AND LEVEL THE ELLIPTICAL
EXERCISER
To move the elliptical exerciser, stand in front of it,
place one foot against one of the wheels, and firmly
hold the upper end of the upright. Pull the upright until
you can move the elliptical exerciser on the wheels.
Carefully move the elliptical exerciser to the desired
location and then lower it. CAUTION: To decrease
the risk of injury, do not attempt to move the ellip-
tical exerciser over an uneven surface.
If the elliptical exerciser rocks slightly on your floor,
turn one or both of the levelling feet under the front
stabilizer until the rocking motion is eliminated.
HOW TO ADJUST THE POSITION OF THE
HANDLEBARS
The upper body arms
can be adjusted to the
height that is the most
comfortable for you. To
adjust each upper body
arm, first loosen the arm
knob. Next, slide the
upper body arm to the
desired position, and
then firmly retighten the
arm knob. Make sure that
both upper body arms
are at the same height.
HOW TO EXERCISE ON THE ELLIPTICAL
EXERCISER
To mount the elliptical exerciser, firmly hold the upper
body arms and carefully step onto the pedal that is in
the lowest position. Next, step onto the other pedal.
Push the pedals until they begin to move with a con-
tinuous motion. Note: The pedal disks can turn in
either direction. It is recommended that you turn
the pedal disks in the direction shown below;
however, for variety, you can turn the pedal disks
in the opposite direction.
To dismount the elliptical exerciser, allow the pedals
to come to a complete stop. CAUTION: The elliptical
exerciser does not have a freewheel; the pedals
will continue to move until the flywheel stops.
When the pedals are stationary, step off the highest
pedal first. Then, step off the lowest pedal.
Pedal
Pedal
Disk
Upper
Body Arm
Upper
Body
Arm
Arm Knob
Wheel
Upright
Leveling Foot