Filter
Top Products
7
2. With the help of a second person, carefully tip
the treadmill onto its right side as shown.
Insert the other Extension Leg (89) into the base
o
f the Uprights (84) as shown. Hold two
Extension Leg Nuts (67) in the bottom of the
Extension Leg. Next, insert two Extension Leg
Bolts (65) into the top of the Extension Leg, and
firmly tighten the Extension Leg Bolts into the
Extension Leg Nuts.
Attach two Base Pads (82) to the base of the
Uprights (84) with two 3/4” Tek Screws (22).
With the help of a second person, carefully raise
the treadmill so that all four Base Pads (22) are
on the floor and the Frame (58) is in a vertical
position (see drawing 3).
84
82
22
6
5
67
2
3. Make sure that the sleeve has been slid over
hole 1 and that the latch knob is locked into hole
1. Pull on the sleeve to make sure it is locked
into place.
Next, make sure that the latch knob is locked
into hole 2. If it is not, pull out the tube until you
see hole 2 and then slide the tube back in until
the latch knob locks into hole 2.
3
89
58
2
2
4. Remove the plastic ties from the ends of the
Latch Shock (69).
Hold the Latch Shock (29) with the large barrel
and latch knob positioned as shown; make sure
all of the holes are aligned (see the inset draw-
ings). Next, attach the lower end of the Latch
Shock to the bracket on the Upright (84) with the
Lower Latch Shock Bolt (39) and a Nut (30).
Then, attach the upper end of the Latch Shock
(29) to the bracket on the Frame (58) with the
Upper Latch Shock Bolt (50) and a Nut (30).
Note: It may be necessary to move the Frame
back and forth to align the Latch Shock with the
Bracket.
29
30
30
84
39
58
4
50
Latch Knob
Top
Bottom
Holes
Holes
Large
Barrel
Latch Knob
Sleeve
Hole 1
Hole 2
Tube