Filter
Top Products
7. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a
secure place. The allen wrench is used to adjust the walking belt (see page 21). To protect the floor or carpet
from damage, place a mat under the treadmill.
4. Make sure that the front edge of the Left Foam Grip (110)
is under the Console Base (82) as shown. Tighten one of
the two Foam Grip Screws (33) into the side of the Right
Foam Grip as shown. Note: It may be necessary to pull
the Foam Grip out (see arrow A) to align the Screw with
the hole in the post.
Attach the other Handrail Extension and Left Foam Grip
(not shown) as described in step 3 and this step. Note:
There is no plastic tie in the left side.
5. Press the Lock Knob Sleeve (70) into the left Upright (69).
Make sure the two Lock Pin Collars (72) and the Spring
(71) are on the Lock Pin (74). Insert the Lock Pin into the
left Upright (69) and tighten the Lock Knob (68) onto the
Lock Pin.
69
70
68
71
72
72
74
5
75
33
A
82
6. Look at the Endcap (58). If the left or right foot on the End-
cap does not touch the floor, the included thick base pads
should be attached to the treadmill as described below.
Refer to assembly step 2. Lower the treadmill frame and
the Uprights (69) as shown. If the left foot of the Endcap
(58) was off the ground, remove the two Base Pads (99)
from the right Upright (69). Attach the included thick
base pads to the Upright. If the right side of the Endcap
was off the ground, attach the thick base pads to the left
Upright.
If either side of the Endcap (58) lifts off the floor when the
treadmill is used, attach the thick base pads as described.
58
6
Foot
Foot
4
7