Filter
Top Products
3. Remove the Latch Knob (125) from the Latch Pin (126).
Make sure that the Latch Pin Collar (127) and the Spring
(128) are on the Latch Pin. (Note: If there are two Latch
Pin Collars, place them on each side of the Spring.)
Insert the Latch Pin into the Latch Housing (82) and
tighten the Latch Knob onto the Latch Pin.
125
128
127
126
82
3
4. With the help of a second person, hold the Console Base
(101) near the Uprights (80, 84).
Cut the plastic ties holding the Wire Harness (74) and
the pulse wire in the Uprights (80, 84).
Locate the Wire Harness (74) and pulse wire in the
Uprights (80, 84). Connect the Wire Harness and the
pulse wire to the connectors on the sides of the Console
Base (101).
Make sure to connect the connectors
properly (see the inset drawings). IF THE CONNEC-
TORS ARE NOT CONNECTED PROPERLY, THE CON-
SOLE MAY BE DAMAGED WHEN THE POWER IS
TURNED ON. The connectors should slide together
easily and snap into place.
If the connectors do not
slide together easily and snap into place, turn a connec-
tor and try to insert it again. Insert the excess Wire
Harness and pulse wire up into the Console Base.
101
80
84
4
74
74
Pulse
Wire
2. With the help of a second person, carefully tip the
Upright Base (97) down as shown. (Note: It may be help-
ful to place your foot on one of the Extension Legs [92]
as you tip the Uprights.)
Make sure that the Extension
Legs remain in the Uprights.
Attach each Extension Leg (92) with two Extension Leg
Bolts (96) and two 1/4” Washers (39) as shown. Thread
a Leveling Foot (95) into each side of the Upright Base
(97);
do not thread the Leveling Feet fully into the
Upright Base.
Attach the two Base Pads (99) to the Upright Base (97)
in the locations shown with two 1” Tek Screws (80).
With the help of a second person, raise the Upright Base
(97) to the vertical position.
96
80
80
99
99
39
96
92
95
95
96
92
96
97
39
39
97
2
6