Filter
Top Products
2. Using a rubber mallet, tap the Lock Knob Sleeve (91)
into the large hole in the left Upright (114). Align the two
small pins on the Lock Knob Spacer (122) with the small
holes in the left side of the Upright. Insert the Lock Knob
Spacer into the Upright. Make sure that the Lock Knob
Sleeve and the Lock Knob Spacer are fully inserted into
the Upright.
Remove the Lock Knob (90) from the Lock Pin (94).
Make sure that the Lock Pin Collar (93) and the Spring
(92) are on the Lock Pin. Insert the Lock Pin into the left
Upright (114) and tighten the Lock Knob onto it.
92
94
91
90
114
2
6
ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed.
Assembly requires a rubber mallet
and a phillips screwdriver (not included).
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
1. With the help of a second person, carefully raise the
Uprights (114) until the treadmill is in the position shown.
4. Make sure that all parts of the treadmill are tightened before you use the treadmill. Keep the included
allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 15). To protect
the floor or carpet from damage, place a mat under the treadmill.
114
1
93
122
127
72
Ridges
71
79
3
3. Observe the two Rear Feet (72) at the rear of the tread-
mill (see figure 1 above). If there is a space between one
of the Feet and the floor, the Foot Spacer (127) will need
to be attached.
Hold the treadmill firmly with both hands, and raise the
treadmill to the storage position as described on page 12.
Using a phillips screwdriver, remove the Screw (71) and the
Rear Foot (72) from the side that was raised off the floor.
Snap the Rear Foot Spacer (127) onto the Rear Foot.
Reattach the Rear Foot to the treadmill Frame (79).
Hold the treadmill firmly with both hands, and lower the
treadmill as described on page 13.
72