Filter
Top Products
5
1. Refer to the drawing on page 4 and identify the
right side of the treadmill. With the help of a second
person, carefully lay the treadmill on its right side.
Firmly slide an Extension Leg (59) into one side of the
Base (32). Make sure that the Extension Leg is turned
so the bracket is on the side shown. Using the Allen
Wrench (102), tighten an Extension Leg Screw (57) into
the Extension Leg and the Base. Without turning the
treadmill over, attach the other Extension Leg in the
same manner.
Stand the treadmill upright so that both Extension Legs
(59) are resting flat on the floor.
2. Refer to HOW TO LOWER THE TREADMILL FOR
USE on page 11. Follow the instructions in step 2 to
lower the treadmill.
Cut the plastic ties holding the cage nuts in the upper
end of each Handrail (60, 62).
Position the Left Handrail (60) on the left Upright (32) as
shown. The bracket on the Extension Leg (59) should
be inside of the lower end of the Left Handrail. Thread
two Handrail Bolts (30) with a Handrail Washers (31)
into the left Upright and the Left Handrail. Do not
tighten the Handrail Bolts yet.
While another person holds the Console Base (46), at-
tach the Right Handrail (62) in the same way. Be care-
ful to avoid damaging the Wire Harness (35).
3. Set the Console Base (46) on the Handrails (60, 62).
Route the Wire Harness (35) under the Console Base
as shown and then press the Wire Harness up into the
Console Base. Insert any slack into the Right Handrail
(62).
Attach the Console Base (46) to the Handrails (60, 62)
with four Screws (29).
57
102
59
32
Bracket
60
46
30
30
30
31
32
59
35
62
30
31
1
2
ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Refer to the drawings below to identify the small
parts used in assembly. Assembly requires the included allen wrench and your own phillips screw-
driver , adjustable wrench , and scissors .
35
62
60
46
29
29
3