Filter
Top Products
1
1
10. Remove the plastic ties from the Right Handrail
(
90) and the Left Handrail (not shown). If neces-
sary, press the Cage Nuts (38) into place.
Have a second person hold the console assem-
b
ly near the Right Upright (78). Remove the long
tie from the Upright Wire (77) and the tie from the
console wire.
Connect the Upright Wire (77) to the console
wire.
See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and
try again. IF THE CONNECTORS ARE NOT
CONNECTED PROPERLY, THE CONSOLE
MAY BE DAMAGED WHEN THE POWER IS
TURNED ON.
Then, insert the connectors into
the Right Upright (78).
Set the console assembly on the Right Upright
(78) and the Left Upright (not shown).
Make sure
that no wires are pinched.
78
Console Assembly
Console
Wire
Long
Tie
77
10
11. Finger tighten two M8 x 25mm Bolts (6) with two
M8 Star Washers (10) into the Left Upright (73)
and the Left Handrail (89).
Next, finger tighten two M8 x 25mm Bolts (6)
with two M8 Star Washers (10) into the Right
Upright (78) and the Right Handrail (90). Then,
tighten all four Bolts.
See steps 4 and 6. Tighten the M10 x 96mm
Bolts (5).
Press the Left Accessory Tray (110) and the
Right Accessory Tray (111) into the Console
Base (88).
6
6
6
10
10
88
110
111
73
89
90
78
10
10
11
77
90
Console
Wire
6
38
Plastic
Ties