Filter
Top Products
DIAGRAM OF THE CONSOLE
8
Clip
Pulse Sensor
Key
Speed Control
Monitor Displays
CAUTION: Before operating the con-
sole, read the following precautions.
¥ Do not stand on the walking belt when turning
on the power.
¥ Always wear the clip (see the drawing above)
while operating the treadmill. When the key is
removed from the console, the walking belt will
stop.
¥ Adjust the speed in small increments.
¥ The training zones marked beside the speed
control are general guidelines only. See page
14 or more information.
¥ To reduce the possibility of electric shock, keep
the console dry. Avoid spilling liquids on the
console and use only a sealable water bottle.
BATTERY INSTALLATION
The console requires two or three "AA" batteries (not
included). Alkaline batteries are recommended. To
install batteries, open the battery cover as shown. Press
the batteries into the battery compartment, with the neg-
ative ends of the batteries (marked ÒÐÓ) touching the
springs. Close the battery cover, push up on the battery
cover tab, and then push the tab forward as shown. Be
sure that the tab locks into place.
STEP BY STEP CONSOLE OPERATION
Step onto the foot rails of the treadmill. Find the clip
attached to the key (see the drawing above), and slide
the clip onto the waistband of your clothing. Follow the
steps below and on page 9 to operate the console.
Insert the key fully into the power switch.
Note: Inserting the
key will not turn on
the displays. The dis-
plays will turn on
when the ON/RESET
button is pressed or
when the walking belt
is started. If you just
installed batteries, the displays will already be on.
1
Incline Control
Note: If there is a thin sheet of clear
plastic on the console, remove it.
Batteries
Battery Cover
Battery
Cover Tab