Filter
Top Products
26
32
Plastic Tie
14
3
6
Bracket
89
70
15
16
14
32
57
41
4
6
3. With the help of a second person, lift the Right Handrail
(57) off the right Upright (14). Hold the Console Base (6)
and the Right Handrail in the position shown. Feed all of
the excess Wire Harness (26) into the Right Handrail,
through the indicated bracket, and down into the right
Upright; bend the Wire Harness, if necessary.
Cut the indicated plastic tie off the Right Handrail (32).
Make sure that the Wire Harness (26) is in the bracket
and insert the bracket into the right Upright (14). Make
sure that the Wire Harness is not pinched.
4. Thread a Handrail Bolt (15) with a Handrail Washer (16)
into the right Upright (14) and the Right Handrail (32). Do
not tighten the Handrail Bolt yet.
Attach the lower end of the Right Handrail (32) to the
Extension Leg (41) with a 3 1/2Ó Handrail Bolt (89), a 3/8Ó
Washer (70), and a Handrail Nut (57).
Tighten all parts used in this step and in step 2.
5. Attach the Console Base (6) to the Left and Right
Handrails (2, 32) with the four Console Screws.
The console requires two "AA" batteries (not included).
Alkaline batteries are recommended. To install batteries,
open the battery cover as shown at the right. Press the
batteries into the battery compartment, with the negative
(Ð) ends of the batteries touching the springs. Close the
battery cover, push up on the tab, and then push the tab
forward. Be sure that the tab locks into place.
6. Attach the Storage Latch (12) to the left Upright (14) with
two 3/4Ó Screws (13). Be careful not to overtighten the
Screws.
7. Make sure that all parts are tightened before you use the treadmill. To protect the floor or carpet, place
a mat under the treadmill.
Console
Screw
6
Tab
2
Batteries
9
32
5
14
12
6
13
Console
Screw