Filter
Top Products
6
4. Attach the Storage Latch (14) to the left Upright (11) with
two Latch Screws (35). Be careful not to overtighten
the Latch Screws.
5. Make sure that all parts are tightened before you use
the treadmill. Keep the included allen wrench in a se-
cure location. The allen wrench is used to adjust the
walking belt (see page 13). To protect the floor or carpet,
place a mat under the treadmill.
35
14
11
4
3. Hold one of the Handrails (1) at an angle as shown and
insert the upper end as far as possible into the right
Upright (11). Keep the lower end of the Handrail away
from the treadmill to avoid scratching the finish. Next,
rotate the lower end of the Handrail to the position shown
by the dotted line. Note: It may be necessary to push on
the lower end of the Handrail in order to position it
against the bracket on the Extension Leg (34).
3a.Refer to drawing 3a. Make sure that the hole in the
Handrail (1) is aligned with the hole in the bracket on the
Extension Leg (34). If the holes are not aligned, rotate the
Handrail away from the treadmill and slide the upper end
of the Handrail out of the Upright (11) slightly. Then, ro-
tate the lower end of the Handrail back to the position
shown by the dotted line in drawing 3. Repeat, if neces-
sary, until the holes are aligned. Make sure that the lower
end of the Handrail is against the bracket on the
Extension Leg. Tighten an Extension Leg Screw (53) into
the bracket and the Handrail.
Attach the other Handrail (not shown) as described above.
11
34
53
34
1
11
Bracket
1
Bracket
3
3a