Filter
Top Products
7
9. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may
be included. Keep the included allen wrenches in a secure place. The large allen wrench is used to adjust the
walking belt (see page 14). To protect the floor or carpet, place a mat under the treadmill.
8. Attach the Storage Latch (14) to the left Handrail (102)
with two 3/4” Screws (13). Be careful not to over-
tighten the Screws.
Lift the treadmill frame (see HOW TO FOLD THE
TREADMILL FOR STORAGE on page 11), but do not
latch it. Make sure that the frame is centered between
the Handrails (102, 103 [not shown]). Firmly tighten all
of the bolts and screws used in assembly steps 3, 4,
5, and 6. Then, lower the frame to the floor.
13
14
102
46
10
21
7. Hold the Console (10) near the Console Base (46). Touch
the Right Handrail (103) to discharge any static. Plug
the widest connector on the Wire Harness (21) into the
widest connector on the Console. If the connector does
not fit easily, rotate it and then connect it. Plug the other
connector on the Wire Harness into the other connector on
the Console. Insert the excess Wire Harness down through
the opening in the Console Base (see the inset drawing
in step 6 above). Securely tighten the plastic tie on
top of the Console Base to prevent the Wire Harness
from slipping. Then, cut off the end of the plastic tie.
Refer to drawing 7a. Press the Book Rack (101) onto the
Console Base (46) in the location shown.
Set the Console (10) on the Console Base (46). Insert
the excess Wire Harness (21) into the large hole in the
side of the Right Handrail (103). Securely tighten the
plastic ties on the bottom of the Console Base to
prevent the Wire Harness from slipping. Then, cut off
the ends of the plastic ties.
Attach the Console (10) to the Console Base (46) with two
1/2” Silver Screws (118) and four 3/4” Screws (13). Start
all six Screws before tightening them; do not over-
tighten the Screws.
7
8
13
13
118
103
Ties
46
110
Ties
103
6
6. Place the Console Base (46) on the Right Handrail (103)
and the Left Handrail (not shown). Attach the Console
Base with four 1 1/4” Screws (105) (only two Screws are
shown).
Do not tighten the Screws yet.
Insert the Wire Harness (21) through the two indicated
plastic ties on the Console Base (46). Next, insert the
Wire Harness up through the opening beside the Console
Cover (110). Make sure that the Console Cover is se-
curely attached to the Console Base.
Refer to the inset drawing. Look at the top of the Console
Base (46). Insert the Wire Harness (21) through the plas-
tic tie on top of the Console Base.
21
21
Tie
46
105
46
101
7a