Filter
Top Products
6
4. Slide the upper end of one of the Handrails (1) onto the
post on one of the Uprights (11). Push the Handrail for-
ward as far as possible. Tighten a Handrail Screw (89)
into the Handrail. Next, align the lower end of the
Handrail with the indicated hole in the Upright. Tighten a
Handrail Bolt (88) with a Handrail Washer (90) into the
Handrail and the Upright.
Attach the other Handrail (1) in the same way.
5. Attach the Storage Latch (14) to the left Upright (11) with
two Latch Screws (89). Be careful not to overtighten
the Latch Screws.
6. Make sure that all parts are tight before you use the treadmill. Keep the included allen wrench in a secure
place. The allen wrench is used to adjust the walking belt (see page 13). Cover the floor beneath the treadmill
to protect the floor or carpet.
11
89
11
89
88 90
90
88
1
1
4
89
14
11
5
3. Locate the two Rubber Rings (91) that have tapered
edges (see the inset drawing). Discard the Rubber Rings
without tapered edges.
Slide a Rubber Ring (91) onto the post on each Upright
(11). Refer to the inset drawing. Make sure that each
Rubber Ring is turned so that the tapered edge is to-
ward the thickest part of the post.
91
91
Post
Post
11
11
3
Tapered Edge