ProForm PFTL39007.0 Treadmill User Manual


 
8
90
7
87
1
1
Large Hole
Console
Wire
22
Console
Ground Wire
6. With the help of a second person, hold a Bolt
Spacer (79) inside the lower end of the Left
Upright (73). Insert an M10 x 96mm Bolt (5) with
an M10 Star Washer (8) into the Left Upright
and the Bolt Spacer. Repeat this step with a
second Bolt Spacer (79), M10 x 96mm Bolt
(5), and M10 Star Washer (8).
Orient the Left Upright (73) and the Left Upright
Spacer (83) as shown. Hold the Left Upright
Spacer and the Left Upright against the Base
(85). Finger tighten the M10 x 96mm Bolts (5);
do not fully tighten the Bolts yet.
Press a Base Endcap (82) into the Base (85).
With the help of a second person, tip the tread-
mill so that the Base (85) is flat on the floor.
83
73
5
85
79
79
82
8
6
5. With the help of a second person, carefully tip
the treadmill onto its right side. Partially fold the
F
rame (48) so the treadmill is more stable; d
o
not fully fold the Frame yet.
Remove and discard the two indicated bolts (A)
and the shipping bracket (B).
Attach a Base Pad (81) to the Base (85) as
shown with a Base Pad Spacer (104) and an M4
x 25mm Screw (2). Then, attach another Base
Pad (81) with only an M4 x 25mm Screw (2).
Remove the M10 Nut (33), the M10 x 50mm
Bolt (27), and the shipping bracket (C) from the
Base (85). Attach a Wheel (86) with the Bolt and
the Nut that you just removed.
Do not over-
tighten the Nut; the Wheel must turn freely.
Discard the shipping bracket.
5
85
86
48
27
33
C
81
2
81
104
2
B
A
7. Set the Console (87) face down on a soft sur-
face to avoid scratching the console assembly.
Identify the Right Handrail (90), which has a
large hole in the location shown. Hold the Right
Handrail near the Console. Attach the console
ground wire to the Right Handrail with a #8 x
1/2" Screw (22).
Next, insert the console wire into the large hole
in the bottom of the Right Handrail and out of
the top as shown. If necessary, use needlenose
pliers to help pull the console wire out.
Attach the Right Handrail (90) and the Left
Handrail (not shown) with six M4 x 19mm
Screws (1) (only one side is shown). Make sure
that no wires are pinched. Start all six
Screws before tightening any of them; do
not overtighten the Screws.