Filter
Top Products
10.Make sure that all parts used in assembly are properly tightened before you use the treadmill. Keep
the included allen wrenches in a secure place for adjustment purposes (see page 13). To protect the floor or
carpet, place a mat under the treadmill.
87
102
53
5
5
5
8
8. Cover the Wire Harness (53) with the Wire Cover (102),
and route the Wire Harness out of the hole in the side of
the Wire Cover. Attach the Wire Cover to the back of the
Console Base (87) with two 3/4” Screws (5). Make sure
that no wires are pinched before you attach the
Console (11) to the Console Base. Tighten the other
four 3/4” Screws into the Console Base and the
Console. Do not overtighten the Screws.
7. Hold the Console (11) near the Console Base (87).
Touch the Right Handrail (59) to discharge any static.
Locate the two wires in the Wire Harness (53) that have
L-shaped connectors on the ends. Press the connectors
onto the two tabs on the switch shown in the inset draw-
ing. Connect the other two wires in the Wire Harness to
the back of the Console (11) in the locations shown by
the arrows in drawing 7. If the connectors do not fit
together easily, rotate them and then connect them.
Set the Console (11) in the Console Base (87). Insert
the excess Wire Harness (53) down into the right
Handrail (4). Securely tighten the two plastic ties to
prevent the Wire Harness from slipping. Cut off the
ends of the plastic ties.
11
53
53
7
87
Tabs
7
Ties
11
59
12
Connectors
Hinges
87
6
6. Insert the Battery Cover (12) up through the bottom of
the Console Base (87), with the hinges in the position
shown. The Battery Cover should pivot down, away from
the Console Base.
Remove the tape from the connectors.
9. Press the Lock Knob Sleeve (73) into the Left Upright
(14). Remove the Lock Knob (54) from the Lock Pin
(66). Make sure that the Lock Pin Collar (56) and the
Spring (55) are on the Lock Pin, and insert the Lock Pin
into Lock Knob Sleeve from the side shown. Tighten the
Lock Knob back onto the Lock Pin.
Lift the treadmill frame (see HOW TO FOLD THE
TREADMILL FOR STORAGE on page 11). Make sure
that the frame is centered between the two Handrails
(4). Firmly tighten all of the bolts and screws used in
steps 3 and 4. Then, lower the frame to the floor.
73
14
4
54
56
55
66
9