Filter
Top Products
27
HOW TO USE THE MAINTENANCE MODE
The console features a maintenance mode that allows
y
ou to calibrate the incline and speed of the treadmill,
update the console firmware, calibrate the screen,
v
iew technical information, and perform a network test.
1. Select the settings mode.
See step 1 on page 25.
2. Select the maintenance mode.
Touch the Maintenance button in the lower right
corner of the screen to
enter the maintenance
mode.
The maintenance mode
main screen will show
information about the model and version of the
treadmill. If the console is connected to the con-
troller of the treadmill, the controller dot will be
green; if it is not, the dot will flash. If the treadmill is
connected to your wireless network, the network
dot will be green; if it is not, the dot will be black.
3. Calibrate the incline system of the treadmill.
Touch the Calibrate Incline button. Then, touch the
Begin button to calibrate the incline system. The
treadmill will automatically rise to the maximum in-
cline level, lower to the minimum incline level, and
then return to the starting position. This will cali-
brate the incline system. Press the Cancel button
to return to the maintenance mode. When the in-
cline system is calibrated, touch the Finish button.
IMPORTANT: Keep pets, feet, and other objects
away from the treadmill while the incline system
is calibrating. In an emergency, pull the key
from the console to stop the incline calibration.
4. Calibrate the speed of the treadmill.
Calibrate the speed of the treadmill only if in-
s
tructed to do so by an authorized service repre-
sentative.
Note: The Calibrate Speed button may not be en-
abled on your treadmill.
5. Update the console firmware.
For the best results, regularly check for
firmware updates.
Touch the Firmware Update button. Next, touch
the WiFi button to check for firmware updates
using your wireless network. Then, touch the Begin
button to check for updates or the Cancel button to
return to the maintenance mode.
To avoid damaging the treadmill, do not turn
off the power or remove the key while the
firmware is being updated.
Note: If you cannot update the console firmware
over your wireless network, you can update the
firmware using a USB drive. Touch the USB button
to install firmware updates using a USB drive. Go
to www.iFit.com and download the firmware update
onto your USB drive. Safely remove the USB drive
from your computer and plug it into the USB port
on the top of the console. Touch the Begin button
to update the firmware or touch the Cancel button
to return to the maintenance mode.
The screen will show the progress of the update.
When the update is complete, the treadmill will turn
off and then turn back on. If it does not, press the
power switch into the off position. Wait for several
seconds, and then press the power switch into the
reset position. It may take a few minutes for the
console to be ready for use.