Filter
Top Products
21
Locate the Reed Switch (33) and the Magnet (39)
on the left side of the Pulley (38). Turn the Pulley
until the Magnet is aligned with the Reed Switch.
M
ake sure that the gap between the Magnet
and the Reed Switch is about 1/8 in. (3 mm). If
n
ecessary, loosen the #8 x 3/4" Machine Screw
(18), move the Reed Switch slightly, and then
retighten the Screw. Reattach the Belly Pan Insert
(not shown) and tip the treadmill so that the Base
(not shown) is flat on the floor. Run the treadmill for
a few minutes to check for a correct speed reading.
PROBLEM: The walking belt slows when walked on
SOLUTION: a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 13.
b. If the walking belt is overtightened, treadmill perfor-
mance may decrease and the walking belt may be-
come damaged. Remove the key and UNPLUG
THE POWER CORD. Using the hex key, turn both
idler roller bolts counterclockwise, 1/4 of a turn.
When the walking belt is properly tightened, you
should be able to lift each edge of the walking belt
2 to 3 in. (5 to 7 cm) off the walking platform. Be
careful to keep the walking belt centered. Then,
plug in the power cord, insert the key, and run the
treadmill for a few minutes. Repeat until the walking
belt is properly tightened.
c. If the walking belt still slows when walked on, see
the front cover of this manual.
Bottom
View
3
3
18
3
9
1/8 in.
38
Idler Roller
Bolts
2–3 in.
b