Filter
Top Products
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires a phillips screwdriver , an adjustable wrench ,
and a rubber mallet .
See the drawings below to identify the small parts needed for assembly. The number in parentheses below
each drawing is the key number of the part, from the PART LIST on page 18. The number following the key
number is the quantity needed for assembly. Note: Some small parts may have been preassembled. If a part
is not in the parts bag, check to see if it has been preassembled.
4
M8 x 3 1/2" Carriage Bolt (51)–2
M8 Nylon
Locknut (57)–4
M8 Washer
(52)–4
M8 Arc
Washer (54)–8
M8 x 1 9/16" Hex Bolt (41)–4
M6 Washer
(55)–2
M6 Arc
Washer (39)–4
M6 Nylon
Locknut (56)–6
M8 Cap Nut
(24)–2
Console
Screw (68)–4
M4 x 1/2"
Screw (49)–16
M6 x 1 3/8" Button
Bolt (46)–4
M8 x 5/8" Button
Screw (45)–6
M6 x 2 1/2" Button
Shoulder Bolt (40)–2
M8 x 3 3/8" Button Screw (42)–2
ASSEMBLY