Filter
Top Products
7
5. Have a second person hold the Upright (6) near
the Frame (2) as shown.
Pull the Wire Harness (48) out of the Frame (2)
and insert it upward through the Upright (6). Do
not let the Wire Harness or the Controller Wires
(110, 95) fall into the Upright; use a piece of
tape or an elastic band to hold the wires in place
until step 15.
Insert the Left and Right Controller Wires (110,
95) downward into the Frame (2). Pull the Right
Controller Wire, which has a tag attached, out of
the right side of the Frame. Then, pull the Left
Controller Wire out of the left side of the Frame.
Insert the Upright (6) into the Frame (2). Attach
the Upright with three M8 x 16mm Patch
Screws (82) and three Star Washers (100).
Avoid pinching the Wires (48, 95, 110)
between the Upright and the Frame.
4. Hook the front ends of the Frame Covers (105,
106) together. Attach each Frame Cover to the
Frame (2) with three M4 x 16mm Self-tapping
Screws (79).
4
79
79
105
2
106
5
6
110
95
82
82
82
48
100
100
100
2
Avoid pinching
the wires during
this step