Filter
Top Products
8. 8
Positionan InnerHandlebarCover(18)andan
OuterHandlebarCover(19)aroundtheLeft
Handlebar(8)asshown.Then,pulltheLeft
HandlebarWire(108)outoftheLeftHandlebar
andinsertitthroughtheInnerHandlebarCover.
AttachtheInnerandOuterHandlebar
Covers(18,19)withthreeM4x 16mmSelfotapo
pingScrews(79)andanM4x 13mmWasher
(93).Startall threeSelf-tappingScrewsbefore
tighteninganyof them.Avoidpinchingthe
Left Handlebar Wire (108) during this step.
Repeat this step for the Right Handlebar and
the Right Handlebar Wire (not shown).
/
/
I
/
/
/
/' / /
/ i
Avoid pinching
the Handlebar
Wires (108, 109)
during this step.
Apply a generous amount of grease to the Pivot
Axle (65) and insert it into the Frame (2).
Pull the Left Controller Wire (110) through the left
Frame Cover (17), and then pull the Right
Controller Wire (111) through the right Frame
Cover.
Attach each Frame Cover (17) to the Frame (2)
with two M4 x 16mm Screws (86). Avoid pinch-
ing the Controller Wires (110, 111) during this
step.
111
Avoid pinching
the Controller
Wires (110, 111)
during this step
10. Connect the Left Handlebar Wire (108) to the
Left Controller Wire (110). Insert the excess wire
into the Left Handlebar (8).
Apply a small amount of grease to both sides of
a Wave Washer (98). Slide the Wave Washer
onto the left side of the Pivot Axle (65). Next,
slide the Left Handlebar (8) onto the Pivot Axle
as shown. Attach the Left Handlebar with an
M10 x 23mm Shoulder Screw (80) and an
M10 x 20mm x lmm Washer (81). Avoid pinch-
ing the wires during this step.
Repeat this step for the Right Handlebar (9).
10
Avoid pinching
the wires during
this step.
81
8O..
Grease
110
9