Filter
Top Products
6
5.
While another person holds the Upright (2) near the
Frame (1) as shown, connect the console wire to the
Reed Switch W
ire (53). Next, connect the console
cable to the Resistance Cable (65) in the following
way:
•
See drawing A. Pull up on the metal bracket on the
Resistance Cable (65), and insert the tip of the con-
sole cable (CC) into the wire clip in the metal brack-
et as shown.
• See drawing B. Firmly pull the console cable (CC)
and slide it into the metal bracket on the Resistance
Cable (65) as shown.
• See drawing C. Using pliers, squeeze the prongs on
the upper end of the metal bracket together.
Slide the Upright (2) onto the Frame (1); be careful
not to pinch the wires or cables. Attach the Upright
with two M10 x 76mm Button Bolts (27),
two M10
Split Washers (43), and two M10 Nylon Locknuts (33).
Do not tighten the Button Bolts yet.
65
27
33
43
53
5
2
1
Make sure that
the wires and
cables do not
get pinched and
damaged during
this step.
65
65
CC
Metal
Bracket
CC
B
A
C
CC
Console
Cable
6. Identify the Left Handlebar (6), which is marked with a
sticker. Insert the Left Handlebar into one of the
Handlebar Arms (5);
make sure that the Handlebar
Arm is turned so the hexagonal holes are on the
indicated side. Attach the Left Handlebar to the
Handlebar Arm with two M8 x 45mm Button Bolts
(50) and two M8 Nylon Locknuts (38). Make sure
that the Nylon Locknuts are inside of the hexago-
nal holes. Do not fully tighten the Button Bolts
yet.
Attach the Right Handlebar to the other Handlebar
Arm (not shown) in the same way
.
6
6
5
50
38
Hexagonal
Holes
Console Wire