Filter
Top Products
8
6. Identify the Right Link Arm (10), which is
marked with a “Right” sticker. Apply a small
amount of grease to the axles on the Right Link
Arm and to two 5/8" Wave Washers (102).
Then, slide a Pivot Spacer (71) and a Wave
Washer onto each axle.
At the same time, slide the Right Link Arm (10)
into the right Upper Body Arm (12) and into the
Right Pedal Arm (8).
Attach the Right Link Arm (10) to the right
Upper Body Arm (12) with a 5/16" x 1" Patch
Screw (81), a Large Axle Cover (94), and a
5/16" Washer (104).
Then, attach the Right Link Arm (10) to the
Right Pedal Arm (8) with a 5/16" x 1" Patch
Screw (81), a Small Axle Cover (67), and a
5/16" Washer (104).
Repeat this step on the other side of the
elliptical exerciser.
Tip: If you have a hard time working the Link
Arms (10, 11) all the way into the Upper
Body Arms (12) and the Pedal Arms (8, 9),
try working them in halfway and then tight-
ening the 5/16" x 1" Patch Screws (81) to
pull them the rest of the way in.
6
10
67
81
12
71
102
8
Grease
Grease
5
5. Identify the Right Pedal Plate (107), which is
marked with an “R” sticker. Attach the Right
Pedal Plate to the Right Pedal Arm (8) with
three M10 x 20mm Patch Screws (108) and
three M10 Split Washers (110).
Identify the Right Pedal Assembly (62), which is
located in a package marked with a “Right”
sticker. Attach the Right Pedal Assembly to the
Right Pedal Plate (107) with five #10 x 1/2"
Screws (79), five M6 Split Washers (111), and
five #10 Fender Washers (80). Tip: To avoid
damaging the Pedal, do not overtighten the
Screws.
Repeat this step for the Left Pedal Plate (not
shown) and the Left Pedal Assembly (56).
80
62
108
107
56
79
79
8
110
111
102
104
81
104
94
71