Filter
Top Products
7
3. Find the Left Pedal (31), which has a ridge on the
right side. Attach the Left Pedal to one of the Pedal
Arms (12) with three M4 x 19mm Round Head
Screws (16) as shown.
Repeat this step to attach the Right Pedal to the other
Pedal Arm (not shown).
4. Identify the Left Handlebar (8) (there is an “L” sticker
on the Left Handlebar). Apply a thin film of the includ-
ed grease to the axle on the Left Handlebar.
Make sure that there are two Pedal Arm Bushings
(42) in each Pedal Arm (12).
Slide a Handlebar Spacer (39) and the Pedal Arm
(12) with the Left Pedal (31) onto the Left Handlebar
(8) as shown. (Note: These parts fit tightly; it may be
helpful to use the rubber mallet.) Next, refer to the
PART IDENTIFICATION CHART on page 5 and iden-
tify the 3/4” Axle Caps (43). Tap a 3/4” Axle Cap onto
the Left Handlebar.
Repeat this step to attach the other Pedal Arm (12) to
the Right Handlebar (62).
5. Apply a thin film of the included grease to the axles
on the Upright (3). Slide a Weld Spacer (49) onto the
left axle on the Upright. Make sure that the open side
of the Weld Spacer is facing the Upright.
Slide a Pedal Arm Spacer (41) onto the left Crank
Arm (59).
Make sure that there are two Rear Pedal Arm
Bushings (11) in the Pedal Arm (12) attached to the
Left Handlebar (8).
With the help of another person, slide the Left
Handlebar (8) onto the left axle on the Upright (3)
while sliding the left Pedal Arm (12) onto the left
Crank Arm (59). (Note: These parts fit tightly; it may
be helpful to use the rubber mallet. In addition, it may
be helpful to rotate the left Crank Arm (59) to a differ-
ent position.)
Tap a 5/8” Axle Cap (57) onto the left axle on the
Upright (3).
Tap a 3/4” Axle Cap (43) onto the left Crank Arm (59).
Repeat this step to attach the Right Handlebar and
the right Pedal Arm (not shown).
3
31
12
16
8
Apply
Grease
62
42
43
12
12
4
39
Ridge
31
5
59
41
11
12
49
57
3
43
8
Apply
Grease