Filter
Top Products
15
ADJUSTING THE BENCH FOR SQUAT EXERCISES
To perform squat or toe raise exercises, fold the Backrest
(15) into the upright position by lifting and pulling it for-
ward as far as it will go.
Remove the Adjustment Tube (29) from the Uprights
(1, 37).
Insert the Weight Rests (21) into one of the two highest
sets of holes in the Uprights (1, 37). Important: For
squat exercises, the Weights Rests must be inserted
from the back, as shown.
WARNING: Always fold the backrest out of the
way when performing squat exercises. Do not sit
on the seat when the backrest is folded.
WARNING: Always place 50 pounds on the leg
lever to balance the bench when performing
squat exercises.
WARNING: Do not stand with your back to the
weight bench when performing squat exercises.
You should be able to see the weight rests while
exercising so that you can safely return the bar-
bell when you finish the exercise.
21
1
29
37
15
58
ATTACHING WEIGHTS TO THE WEIGHT CARRIAGE
To use the Lat Tower (9), slide the desired amount of
weight (not included) onto the weight tube on the Weight
Carriage (47).
WARNING: Do not place more than 130 pounds on
the weight carriage.
When performing an exercise during which you
are sitting on the bench with your back to the lat
tower, make sure there is plenty of space between
your back and the weight carriage. Always lower
the weight carriage in a controlled manner. Never
let the weight carriage drop.
47
9