Filter
Top Products
5
3
4
5
2
16
Adjustment
Brackets
Bolt
Holes
49
39
3
34
9
40
40
1
Adjustment
Brackets
2
14
26
1
38
17
38
28
1
14
35
3. Identify the Right Upright (2) by noting the posi-
tions of the adjustment brackets and the bolt
holes near the lower end. Attach the Right
Upright to the indicated Stabilizer (3) with two
M10 x 95mm Bolts (49), two 10mm Washers
(34), and two 15mm x 70mm Spacers (39). Do
not tighten the Bolts yet.
Press a 76mm Slotted Endcap (16) into the bot-
tom of the Right Upright (2); it may be necessary
to turn the Slotted Endcap so it fits around the
15mm x 70mm Spacers (39).
Attach the Left Upright (not shown) to the other
Stabilizer (not shown) in the same manner.
4. Insert the Right Barbell Lock Pin (38) through
the welded tube on a Weight Rest (1). Tighten
an M10 Nylon Locknut (35) onto the Right
Barbell Lock Pin.
Attach the Left Barbell Lock Pin (28) to the other
Weight Rest (1) in the same manner.
Slide a 76mm Plastic Bushing (14) onto each
Weight Rest (1). The Plastic Bushings must
be turned as shown.
5. Insert a 32mm Square Endcap (40) into each
end of the Adjustment Bar (9). Set the Adjust-
ment Bar in the lowest set of adjustment brackets
on the Right and Left Uprights (2, 26).
Refer to step 2 and tighten the six M10 Nylon
Locknuts (35) used in that step. Do not over-
tighten the Nylon Locknuts. Next, refer to step
3 and tighten the four M10 x 95mm Bolts (49)
used in that step. Do not overtighten the
Bolts; the Uprights will be damaged and you
will not be able to fully insert the Weight
Rests (1) into the Uprights.
Insert the Weight Rest (1) with the Right Barbell
Lock Pin (38) into the Right Upright (2). Press
the 76mm Plastic Bushing (14) firmly into the
top of the Right Upright. Insert an Adjustment
Pin (17) through the holes in the Right Upright
and the Weight Rest (1).
Attach the other Weight Rest (1) to the Left
Upright (26) in the same way. Make sure that
both Weight Rests are at the same height.