Filter
Top Products
6
5.
Attach the Backrest Bracket (10) to the Backrest
Tubes (6) with four M10 x 45mm Button Bolts
(74), four M10 Washers (67), and four M10 Nylon
Locknuts (69). Make sure the Backrest Tubes
are oriented so that the indicated holes are
closer to the bottom. Do not tighten the
Locknuts yet.
3
4
4
25
73
11
72
73
24
7
69
79
79
1
Lubricate
71
1
69
77
75
Lubricate
Handle
Tube
8
5
6
67
67
Holes
74
74
69
69
10
3. Attach the Leg Lever Bracket (7) to the Bench
Frame (1) with two M10 x 68mm Button Bolts
(79) and two M10 Nylon Locknuts (69).
Attach the W
eight Tube (11) to the Leg Lever (4)
with an M8 x 58mm Button Bolt (71), two M8
Washers (73), a 10mm Spacer (25), and an M8
Nylon Locknut (72). Press a 25mm Round Outer
Cap (24) onto the Weight Tube.
Lubricate an M10 x 68mm Button Bolt (79) with
grease. Attach the Leg Lever (4) to the Leg Lever
Bracket (7) with the Bolt and an M10 Nylon
Locknut (69).
Do not overtighten the Locknut;
the Leg Lever must be able to pivot easily.
4. Lubricate an M10 x 78mm Button Bolt (75) with
grease. Attach the lower hole in the Adjustment
Lever (8) to the tube on the bottom of the Bench
Frame (1) with the Bolt and an M10 Nylon Locknut
(69).
Do not overtighten the Locknut; the
Adjustment Lever must be able to pivot easily.
Hold the handle on the Adjustment Lever (8) so
that the upper hole is above the Bench Frame (1).
Slide the M10 x 62mm Flat Head Screw (77)
through the indicated side of the Lever, over the
Bench Frame, and tighten it into the other side of
the Adjustment Lever. Make sure that the threads
of the Screw show through the Adjustment
Lever. Do not overtighten the Screw.