Filter
Top Products
Place all parts of the AIR WALKER in a cleared area and remove the packing materials. Do not dispose of the
packing materials until assembly is completed. Read through all assembly steps before you begin.
Assembly requires an allen wrench (included) a phillips screwdriver
and an adjustable wrench (not included).
4
ASSEMBLY
2. Slide a Lock Washer (16) onto the Lock Knob (32).
Insert the Lock Knob (32) into the hole near the top of
the Left Leg (2). Tighten the Lock Knob into the Link
Plate (7).
3. The Electronic Monitor (9) requires two ÒAAÓ
batteries (not included). Alkaline batteries are
recommended. Press the tab on the battery cover
and remove the battery cover from the Monitor.
Insert two batteries into the Monitor. Make sure
that the negative (Ð) ends of the batteries are
touching the springs in the Console. Close the
battery cover.
1. Refer to figure 1b. Move to the front of the AIR
WALKER and place your hands on the Frame (1)
in the indicated locations. Hold the AIR WALKER
in the position shown in figure 1a. Put your foot on
the round tube. Using your foot, pull the round
tube toward you until the Uprights (5, 6) come to
rest against the stops. Make sure that the Uprights
are completely extended and are resting against
the stops before you proceed with assembly.
Fig. 2
Fig. 3
9
Tab
Battery
Cover
Batteries
32
16
2
7
Fig. 1a
Front
Foot
Hands
Round
Tube
Back
Fig. 1b
6
5
Stop
1
1