Filter
Top Products
16
36. Grease an M8 x 22mm Shoulder Bolt (39). Attach
the Butterfly Cable (106) to the Right Butterfly
A
rm (7) with the Bolt and an M8 Nylon Locknut
(91).
Make sure the flat edge of the Cable is
a
gainst the Butterfly Arm.
38. Wrap the Short Cable (108) over a 90mm Pulley
(63). Attach the Pulley and two Half Finger
Guards (66) to the Double “U”-bracket (61) with
an M10 x 48mm Bolt (84) and an M10 Nylon
Locknut (90). Make sure the Finger Guards are
oriented as shown.
40. Identify the Weight Cable (110). Route the
Cable up through the Right Top Frame (5) and
over a 90mm Pulley (63). Attach the Pulley inside
the
T
op Frame with an M10 x 80mm Bolt (75),
two M10 W
ashers (99), two M10 x 19mm
Spacers (102), and an M10 Nylon Locknut (90).
39. Attach the end of the Short Cable (108) to a “U”-
bracket (50) with an M8 Washer (98) and an M8
Nylon Locknut (91). Note: Do not completely
tighten the Locknut; it should be tightened so
that only two threads of the Cable show past
the Locknut, as shown in the inset drawing.
37. Identify the Short Cable (108). Attach the Cable
to the M8 x 96mm Bolt (83) used in step 6 with
an M8 Washer (98), an M8 x 13mm Spacer (103),
and an M8 Nylon Locknut (91).
36
37
39
40
38
91
91
39
91
7
106
Grease
83
98
91
103
108
63
84
66
61
90
66
108
50
98
108
108
63
5
99
99
75
90
110
102
102
2
Flat
Edge