Filter
Top Products
4. Turn a Handrail Extension (34) so that the two larger
holes are on the bottom as shown. Insert the Handrail
Extension as far as possible into the post on the left
Upright (64). If necessary, tap the Handrail Extension with
a rubber mallet to fully insert it. Next, attach the Handrail
Extension by tightening three Extension Screws (35) into
the indicated holes.
Identify the Left Foam Grip (31) (see the inset drawing).
Remove any remaining paper from the two indicated
pieces of Foam Tape (82). Apply a small amount of water
to the Foam Tape. Slide the Left Foam Grip as far as pos-
sible onto the post on the left Upright (64). Note: It may
be helpful to lubricate the Handrail Extension (34)
with soapy water. Press two Plastic Fasteners (9) into
the Foam Grip and the Handrail Extension (34). If neces-
sary, use a blunt object to press in the Fasteners.
Attach the other Handrail Extension (not shown) and the
Right Foam Grip (43) as described above. Note: Make
sure that the Extension Screws (35) are attached on the
outside of the post as shown.
3
3. With the help of a second person, carefully tip the
Uprights (64) back to the vertical position.
Attach the Latch Assembly (32) to the left Upright (64)
with two Extension Screws (35).
Note: There may already be two pieces of Foam Tape
(82) attached to each post. If there are not, peel the paper
off two of the included pieces of Foam Tape. Press the
Foam Tape onto the left post in the locations shown.
Press the other two pieces of Foam Tape onto the right
post in the same way.
32
Post
35
64
31
64
9
35
Post
34
4
5. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a
secure place; the allen wrench is used to adjust the walking belt (see page 24). To protect the floor or carpet
from damage, place a mat under the treadmill.
31
43
82
82
Holes