Filter
Top Products
8
5. Attach the end of the ground wire to the small hole in the
side of the Right Handrail (72) with a Ground Screw (75).
Ground
Wire
72
75
5
47
Ties
72
7
7. Place the Console Base (47) on the Right Handrail (72)
and the Left Handrail (not shown). Attach the Console
Base with four 3/4” Screws (2) (only two Screws are
shown). Do not overtighten the Screws.
Insert the Wire Harness (42) through the two indicated
plastic ties on the Console Base (47). Next, touch the
Right Handrail (72) to discharge any static. See the
inset drawing. Find the 5-pin connector on the end of the
Wire Harness. Insert the connector into the red socket be
-
neath the console. The connector should slide easily
into the socket and snap into place. If the connector
does not slide easily and snap into place, turn the connec
-
tor and then insert it. Insérez le connecteur à 6 goupilles
dans la socle noir sous la console de la mème manière.
Make sure that the connectors and wires appear as
shown in the inset drawing. IF THE CONNECTORS ARE
NOT INSERTED PROPERLY, THE CONSOLE MAY BE
DAMAGED WHEN THE POWER IS TURNED ON.
42
43
2
6-pin
42
5-pin
2
2
6. Turn the Console Base (47) upside-down; be careful not
to scratch the Console (43). Set the Crossbar (40) in the
Console Base, with the indicated small holes on top.
Attach the Crossbar (40) to the Console Base (47) with two
3/4” Screws (2).
Do not overtighten the Screws.
6
47
40
43
Small
Holes