Filter
Top Products
8
CONSOLE DIAGRAM
Clip
Key
Displays
LED Track
Incline Display
STEP-BY-STEP CONSOLE OPERATION
Before operating the
console, make sure that
the on/off switch near
the power cord is in the
on position.
Next, make sure that the key is removed from the
console and then plug in the power cord (see HOW TO
PLUG IN THE POWER CORD on page 7).
When you are ready to begin exercising, step onto the
foot rails of the treadmill. Find the clip attached to the
key (see the drawing above), and slide the clip onto
the waistband of your clothing.
Follow the steps below to operate the console.
Insert the key fully into the console.
When the key is
inserted, one indicator
will light in the incline
display, one indicator
will light in the LED
track, and the four
displays will light.
Press the Speed
▲▲
button to start the walking
belt.
A moment after the
Speed
▲▲
button is
pressed, the walking belt
will begin to move. Hold
the handrails and care-
fully begin walking.
As you exercise, change the speed of the walking
belt as desired by pressing the Speed buttons.
To stop the walking belt,
press the Stop/Reset but-
ton. The Time/Pace dis-
play will begin to flash. To
restart the walking belt,
press the Speed
▲▲
button
again. To stop the walking belt and reset the dis-
plays, press the Stop/Reset button for about two
seconds.
2
1
CAUTION:Before operating the
console, read the following precautions.
• Do not stand on the walking belt when turn-
ing on the power.
• Always wear the clip (see the drawing above)
while operating the treadmill.
• Adjust the speed in small increments.
• To reduce the possibility of electric shock, keep
the console dry. Avoid spilling liquids on the
console, and use only a sealed water bottle.
On
Position
Note: If there is a thin sheet of clear plastic
on the face of the console, remove it.