Filter
Top Products
8
CAUTION:Before operating the con-
sole, read the following precautions.
• Do not stand on the walking belt when turning
on the power.
• Always wear the clip (see the drawing above)
while operating the treadmill. When the key is
removed from the console, the walking belt will
stop.
• Adjust the speed in small increments.
• To reduce the possibility of electric shock, keep
the console dry. Avoid spilling liquids on the
console and use only a sealable water bottle.
BATTERY INSTALLATION
The console requires three “AA” batteries (not
included). Alkaline batteries are recommended.
To install batteries, open the battery cover under the
console as shown below. Press three batteries into the
battery com-
partment.
Make sure
that the nega-
tive ends of
the batteries
(marked “–”)
are touching
the springs.
Close the bat-
tery cover.
STEP BY STEP CONSOLE OPERATION
Before operating the console, make sure that the
power cord is properly plugged in. (See HOW TO
PLUG IN THE POWER CORD on page 7.) If there is a
thin sheet of clear plastic on the face of the console,
remove it.
Next, step onto the foot rails of the treadmill. Find the
clip attached to the key (see the drawing above), and
slide the clip onto the waistband of your clothing.
Follow the steps on pages 9 and 10 to operate the
console.
Batteries
Battery
Cover
DIAGRAM OF THE CONSOLE
Pulse
Sensor
On/Reset
Button
Incline
Control
Clip
Key
Speed
Control
Displays