Filter
Top Products
6
1. Position the Stabilizer (4) against the saddle on the
Frame (1). Insert two M10 x 75mm Button Head Bolts
(45) through the Frame and the Stabilizer. Tighten
M10 Nylon Locknuts (46) onto the Button Head Bolts.
2. Attach a Pedal (9) to the Left Pedal Arm (7) with three
M4 x 16mm Screws (51).
If there is not a Wheel (60) on the Left Pedal Arm (7),
attach a Wheel in the following way: Place a Wheel
inside of a Wheel Cover (59). Hold the Wheel and the
Wheel Cover inside of the bracket on the Left Pedal
Arm (7). Insert an M8 x 55mm Hex Head Bolt (63)
through the bracket, Wheel Cover, and Wheel. Tighten
an M8 Nylon Locknut (64) on the Hex Head Bolt.
Assemble the Right Pedal Arm (not shown) in the
same way.
3. Insert a Pedal Bolt (36) through the bushings in the
Left Pedal Arm (7). Using the included flat wrench,
tighten the Pedal Bolt into the left arm of the Crank
(38). Next, back the Pedal Bolt out of the Crank
half of a turn. While holding the Pedal Bolt station-
ary, tighten a 1/2Ó Nylon Locknut (37) onto it.
Attach the Right Pedal Arm (not shown) in the same
way.
ASSEMBLY
Place all parts of the PROFORM
¨
L.E.X. in a cleared area and remove the packing materials. Do not dispose
of the packing materials until assembly is completed.
In addition to the included allen wrench and flat wrench, a phillips screwdriver and two
adjustable wrenches are required for assembly.
3
2
1
46
46
45
4
45
1
59
Bracket
60
64
63
7
9
38
7
36
Bushings
37
51