Filter
Top Products
7. Identify the Left Pedal Leg (13), which is marked with a
sticker. Attach a Pedal (12) to the Left Pedal Leg with
two M6 x 54mm Bolts (75), two M6 Washers (76), and
two M6 Nylon Locknuts (59).
Attach the other Pedal to the Right Pedal Leg (not
shown) in the same way.
13
75
76
76
59
7
5. The Console (5) requires four “D” batteries (not includ-
ed); alkaline batteries are recommended. Refer to the
inset drawing. Press the tab on the battery cover, and
lift off the battery cover. Insert four batteries into the
Console. Make sure that the batteries are oriented
as shown by the diagram inside the Console.
Reattach the battery cover.
While another person holds the Console (5) in the
position shown, connect the wire harness on the
Console to the Upper Wire Harness (20). Insert the
excess wire harness into the Upright (2). Attach the
Console to the Upright (2) with three M10 x 27mm
Screws (71) and three M10 Split Washers (70). Be
careful to avoid pinching the wire harnesses.
Snap the bookrack onto the Console (5).
5
Bookrack
20
71
71
6. Identify the Left Handlebar (9), which is marked with a
sticker. Apply a generous amount of the included
grease to the left and right axles on the Upright (2).
Carefully slide an Upright Spacer (26), a Handlebar
Spacer (25), the Left Handlebar (9), and a Handlebar
Cap (23) onto the left axle on the Upright (2) as shown.
Slide an M8 Washer (77) onto an M8 x 19mm Button
Screw (22), and tighten the Button Screw into the axle.
Attach the Right Handlebar (not shown) in the same way.
Grease
6
7
2
Wire
Harness
70
70
71
26
25
9
2
23
22
77
12
5
Tab
Batteries
Battery
Cover
5