Filter
Top Products
7
5. Make sure that all parts are properly tightened before you use the treadmill. Place a mat beneath the
treadmill to protect the floor or carpet.
For your benefit, we recommend that you familiarize yourself with
the TROUBLESHOOTING section on pages 27 and 28.
68
5
Collar
20
55
Knob
105
3
Small
Holes
3. With the help of a second person, raise the treadmill
Frame (55). Hold the Latch Housing (68) and the Latch
Housing Cover (5) against the sides of the Frame as
shown. Loosely thread the two blunt-tipped 1/2” Screws
(105) into the Latch Housing Cover and the Latch Housing
as shown. Do not tighten the Screws yet.
Remove the knob from the pin. Make sure that the collar
and the spring are on the pin. The collar should be on the
indicated side of the spring. Insert the pin into the Latch
Housing (68), and tighten the knob back onto it.
Align the pin with the hole in the Left Handgrip (63) by slid-
ing the Latch Housing (68) up or down. Make sure that the
pin can be inserted fully into the hole. Hold the Latch
Housing in place as you tighten the two 1/2” Tek Screws
(20) into the Latch Housing and the Frame (55). Then,
tighten the 1/2” Screws (105). Note: It may be necessary
to pull on the knob to access and tighten the Screws.
Hole
63
Spring
Pin
4
Console
Assembly
4. Remove the backing from the indicated tape on the console
assembly. Press the Book Holder (23) firmly onto the tape.
23
Tape
105
20