Filter
Top Products
9
10.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may
be included. Keep the included allen wrenches in a secure place. The large allen wrench is used to adjust the
walking belt (see page 17). To protect the floor or carpet, place a mat under the treadmill.
8. Attach a Wheel (66) to the inner side of each Extension
Leg (63) with a Wheel Bolt (64) and a Wheel Nut (32) as
shown.
Do not overtighten the Wheel Bolt. The Wheel
should be able to spin freely.
Lift the treadmill frame (see HOW TO FOLD THE
TREADMILL FOR STORAGE on page 14), but do not
latch it. Make sure that the frame is centered between
the Handrails (not shown).
Firmly tighten the 3/4” Bolts
(not shown) used in assembly step 4. Then, lower the
frame to the floor.
63
64
66
32
8
9. Attach the Weight Rack (24) to the Uprights (69) as shown
with four 3/4” Screws (2). Set the hand weights (not shown)
on the Weight Rack, with the lightest weights in the center.
9
69
69
24
2
2