Filter
Top Products
8
2b
A
116
PULSE
Jack
If you purchase the optional heart rate monitor (see
page 19), follow the steps below to install the receiver in-
cluded with the heart rate monitor.
1. Make sure the treadmill is unplugged. Remove the six or
seven indicated Screws (46) from the back of the
Console Base (116).
2. Connect the Short Jumper Wire (B) to the wire on the
Receiver (A). Connect the other end of the Jumper Wire
to the PULSE jack on the back of the Console (see draw-
ing 2b). Next, peel the paper off the pad on the back of
the Receiver. Turn the Receiver so the cylinder is on
the side shown, and press the Receiver into the bottom
of the Console Base (116) in the indicated location. Note:
A Long Jumper Wire is included but will not be used.
Make sure that no wires are pinched. Reattach the
back of the Console Base (116) with the Screws (46) (see
step 1 above).
116
46
1
B
2a