Filter
Top Products
6
ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver .
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
1. With the help of a second person, carefully raise the
treadmill to the upright position.
While a second person tips the treadmill to one side and
holds it, insert one of the Extension Legs (103) into the
treadmill as shown. Make sure that the Extension Leg is
turned so the Base Pad (97) is on the bottom.
Next, tip the treadmill to the other side and insert the
other Extension Leg (not shown) in the same way. Lower
the side of the treadmill so that both Extension Legs
(103) are resting flat on the floor.
3. With the help of a second person, carefully tip the
Uprights (82) down as shown. Make sure that the
Extension Legs (103) remain in the Uprights.
Attach each Extension Leg (103) with two long
Extension Leg Screws (101) and a Base Pad (97) as
shown.
With the help of a second person, carefully tip the
Uprights (82) back to the vertical position.
Note: One replacement Base Pad (97) and Base Pad
Spacer (9) may be included. Use the extra Pad and
Spacer if one becomes worn or needs to be replaced.
103
97
1
3
101
97, 9
97, 9
97, 9
97
97
101
103
103
82
2. Hold the treadmill firmly with both hands, and lower the
treadmill to the floor. CAUTION: To decrease the pos-
sibility of injury, bend your legs and keep your back
straight.
2