Filter
Top Products
5
1. With the help of a second person, carefully raise the
treadmill to the upright position. While a second person
tips the treadmill to one side and holds it, insert one of
the Extension Legs (103) into the treadmill as shown.
Make sure that the Extension Leg is turned so the
Warning Decal (20) is on top.
Next, tip the treadmill to the other side and insert the
other Extension Leg (not shown) in the same way. Lower
the side of the treadmill so that both Extension Legs
(103) are resting flat on the floor.
20
103
1
2. Refer to HOW TO LOWER THE TREADMILL FOR
USE on page 10. Follow the instructions in step 2 to
lower the treadmill.
Attach the latch spacer and the latch support to the left
Upright (82) with a 3/4Ó Screw (81). Make sure that the
Screw is tight, but do not overtighten it; if the Screw
is overtightened, the latch will not slide smoothly.
Refer to the inset drawing. Assemble the latch in the
bracket with the springs as shown.
Attach the Latch (77) to the left Upright (82) with two
3/4Ó Screws (81).
77
81
81
Support
Spacer
82
77
2
ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver and adjustable wrench .
Springs
Bracket
Latch
3. Slide the upper end of a Handrail (75) onto the right
Upright (82) as shown. Note: It will be necessary to
pivot the Handrail to the side and back repeatedly
(see arrow A) while pushing on the Handrail (see
arrow B) to slide it fully onto the Upright. Next, pivot
the lower end of the Handrail down, push it toward the
right Upright, and then align it with the indicated hole.
Slide the other Handrail (75) onto the left Upright (82) as
described above.
82
75
75
82
Hole
3
B
A