Filter
Top Products
4. Hold one of the Handrails (1) at an angle as shown and
insert the upper end into the right Upright (11) as far as
possible. Keep the lower end of the Handrail away from
the treadmill to avoid scratching the finish.
Next, rotate the lower end of the Handrail (1) to the posi-
tion shown by the dotted line. Note: It may be necessary
to pull back on the lower end of the Handrail in order to
position the Handrail against the bracket on the
Extension Leg (34).
Make sure that the hole in the bracket on the Extension
Leg (34) is aligned with the hole in the Handrail (1). If the
holes are not aligned, rotate the Handrail away from the
treadmill and slide the upper end of the Handrail slightly
out of the Upright (11). Then, rotate the lower end of the
Handrail back to the position shown by the dotted line.
Repeat, if necessary, until the holes are aligned.
4a.Refer to drawing 4a. Make sure that the lower end of the
Handrail (1) is against the bracket on the Extension Leg.
Tighten an Extension Leg Screw (53) into the bracket and
the Handrail.
Attach the other Handrail (not shown) as described above.
5. Attach the Storage Latch (14) to the left Upright (11) with
two Latch Screws (3). Be careful not to overtighten the
Latch Screws.
11
34
53
34
1
Bracket
1
Bracket
4
4a
3
14
11
5
88
6
6. Remove the backing from the Adhesive Clip (33). Press
the Adhesive Clip onto the right Upright (11) in the indi-
cated location. Press the Allen Wrench (88) into the
Adhesive Clip.
11
33
7. Make sure that all parts are tightened before you use
the treadmill. To protect the floor or carpet, place a mat
under the treadmill.
6