Filter
Top Products
5
1. Refer to the drawing on page 4 and identify the left
side of the treadmill. With the help of a second person,
carefully lay the treadmill on its left side.
Firmly slide an Extension Leg (99) into each side of the
Base (70) as shown. Make sure that the Extension Legs
are turned so the Base Pads (89) are on the indicated
sides. Using the included Allen Wrench (92), attach each
Extension Leg with an Extension Screw (93).
With the help of a second person, carefully raise the
treadmill to the vertical position so both Extension Legs
(99) are resting flat on the floor.
3. See HOW TO LOWER THE TREADMILL FOR USE on
page 21. Follow the instructions on page 21 to lower the
treadmill.
Cut the two shipping ties from the Right and Left
Handrails (72, 73).
93
93
92
70
99
99
89
89
1
73
72
Shipping
Ties
3
2. Remove the indicated Screws (4) from the treadmill.
Attach the plastic Catch (5) to the Frame (1) with one
Screw (4).
Without removing the tape from the Latch Bracket (60)
and Latch Spacer (66), hold them against the left
Upright (70) as shown. Attach the Latch Bracket and
Latch Spacer with four Screws (4). Make sure that the
Screws are tight, but do not overtighten them; if the
Screws are overtightened, the storage latch will not
slide smoothly. Remove the tape.
Note: The inset drawing shows how the Latch Bracket
(60), Latch Springs (68), Storage Latch (69), and Latch
Spacer (66) fit together.
ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove the packing materials. Do not
dispose of the packing materials until assembly is completed.
Assembly requires the included allen wrench and your own adjustable wrench and
scissors .
66
4
4
70
5
60, 66
60
69
68
2
1