Filter
Top Products
1. With the help of a second person, carefully raise the
treadmill to the upright position. While a second person
tips the treadmill to one side and holds it, insert one of
the Extension Legs (103) into the treadmill as shown.
Make sure that the Extension Leg is turned so the
Warning Decal (20) is on top. Tighten two of the four
Short Screws (101) into the treadmill and the Extension
Leg.
Next, tip the treadmill to the other side and attach the
other Extension Leg (not shown) in the same way. Lower
the side of the treadmill so that both Extension Legs
(103) are resting flat on the floor.
1
20
101
103
2. Refer to HOW TO LOWER THE TREADMILL FOR
USE on page 11. Follow the instructions in step 2 to
lower the treadmill.
Without removing the tape from the Latch (77), attach
the Latch to the left Upright (82) with two 3/4Ó Screws
(81). Make sure that the Screws are tight, but do not
overtighten them; if the Screws are overtightened,
the Latch will not slide smoothly. After the Latch is
attached, remove any visible tape.
Note: The inset drawing shows how the parts of the
Latch (77) fit together.
77
81
82
2
Spacer
Springs
Bracket
77
3. Cut the plastic tie off the bracket on the base of each
Upright (82). Next, cut the plastic tie off the Left Handrail
(74). Position the Left Handrail on the left Upright (82).
The bracket on the base of the left Upright should be in-
side of the lower end of the Left Handrail, as shown in
inset drawing C.
Refer to inset drawing A. While a second person holds the
Right Handrail (85) and the Console (not shown) near the
right Upright (82), cut the indicated plastic ties off the
Right Handrail. Do not cut the other plastic tie in the
Right Handrail. Next, cut the plastic tie off the Upright
Wire Harness (34) in the right Upright (82). Do not drop
the Upright Wire Harness into the right Upright.
Refer to inset drawing B. Connect the Console Wire Harness
(48) to the Upright Wire Harness (34). The latch on the
Console Wire Harness should snap onto the Upright Wire
Harness. If the Wire Harnesses do not fit together easily,
turn them; do not force the Wire Harnesses together.
Plastic Tie
74
82
Plastic
Tie
3
ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver , adjustable wrench and scissors .
48
34
Plastic
Ties
A
B
34
48
85
82
Do not
cut
Bracket
74
C
5