Filter
Top Products
3. Attach the Latch Assembly (82) to the Left Upright (84)
with the two Latch Screws (134). Start both Latch Screws
before tightening either of them. Note: The Latch Screws
may be preattached to the Left Upright.
134
84
82
5. Set the Console Base (101) on the Uprights (80, 84).
Attach the Console Base to the each Upright with two
Upright Bolts (76) and two Internal Star Washers (77). Be
careful not to pinch the Wires (not shown) in the
Uprights. Note: Start all four Upright Bolts before tight-
ening any of them.
Make sure that the Left and Right Trays (109, 111) are
pressed into the Console Base (101).
76
77
101
76
77
111
109
80
84
5
6
3
4. Refer to step 6 and locate the four Upright Bolts (86).
Loosen the Upright Bolts two to three turns.
With the help of a second person, hold the Console Base
(101) near the Uprights (80, 84).
Cut the plastic ties holding the Wire Harness (74) and
the Pulse Wire (70) in the Uprights (80, 84). Connect the
Wire Harness and the Pulse Wire to the connectors on
the sides of the Console Base (101).
Make sure to con-
nect the connectors properly (see the inset draw-
ings). IF THE CONNECTORS ARE NOT CONNECTED
PROPERLY, THE CONSOLE MAY BE DAMAGED
WHEN THE POWER IS TURNED ON. The connectors
should slide together easily and “snap” into place.
If
the connectors do not slide together easily and snap into
place, turn a connector and try again. Insert the excess
Wire Harness and Pulse Wire up into the Console Base.
Press the Right and Left Top Endcaps (75, 81) into the
Uprights (80, 84) as shown.
101
80
75
81
84
4
74
70
77