Filter
Top Products
7. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a
secure place. The allen wrench is used to adjust the walking belt (see page 13). To protect the floor or carpet,
place a mat under the treadmill.
5. Place the Console Base (46) on the posts on the Upright.
Make a loop with the indicated plastic ties and insert the
two Wires (21) through the loops. Pull out only enough of
the two Wires to connect them to the connectors in the
Console Base. Plug the Wires fully into the connectors.
Tighten the loops and cut off the excess plastic tie.
WARNING: Do not disconnect or connect the Wires
while the treadmill power cord is plugged in.
Refer to drawing 5b. Thread six Console Screws (99) into
the Uprights (11) and the Console Base (46). After all six
Console Screws have been started, tighten the Screws
until they are snug; do not overtighten the Screws.
Ties
99
46
11
11
99
99
11
46
21
21
5a
5b
6. Attach the Storage Latch (14) to the left Upright (11) with
two Small Screws (13).
Be careful not to overtighten
the Latch Screws.
13
14
11
6
Tie
21
11
Ties
11
4
6
3. Remove the Handrail Screw (53) from one of the
Handrails (1). Insert the Handrail into the tube at the top
of the left Upright (11), and align the hole in the Handrail
with the slotted hole in the Upright. Loosely thread the
Handrail Screw into the Handrail, rotate the Handrail until
the Screw is touching one end of the slotted hole, and
then fully tighten the Screw.
Attach the other Handrail (1) to the right Upright (11) in
the same way.
4. Thread the two included wire ties through the indicated
holes in the tube on right side of the Upright (11).
Look into the Right Handrail (88) and make sure the Wires
(21) have been secured to the side shown. Tighten the
wire ties and cut off the excess from the ends.
11
1
53
53
1
3
Slotted
Hole