Filter
Top Products
Place all parts of the AIR WALKER in a cleared area and remove the packing materials. Do not dispose of the
packing materials until assembly is completed. Read through all assembly steps before you begin.
Assembly requires the included allen wrench and your own phillips screwdriver
and adjustable wrench .
4
ASSEMBLY
2. Slide a Lock Washer (16) onto the Lock Knob (32).
Insert the Lock Knob into the hole near the top of
the Left Leg (2). Tighten the Lock Knob into the
Link Plate (7).
3. The Electronic Monitor (9) requires two ÒAAÓ
batteries (not included). Alkaline batteries are
recommended. Press the tab on the battery cover
and remove the battery cover from the Monitor.
Insert two batteries into the Monitor. Make sure
that the negative (Ð) ends of the batteries are
touching the springs in the Console. Close the
battery cover.
1. Refer to figure 1a. Stand at the front of the AIR
WALKER, hold the Frame (1) in the indicated
locations, and raise the AIR WALKER to the
position shown. Refer to figure 1b. Put your foot
on the round tube. Using your foot, pull the round
tube toward yourself until the Uprights (5, 6) are
fully extended. Before you proceed with
assembly, make sure that the Uprights are fully
extended and are resting against the stops
(see figure 1a).
Fig. 2
Fig. 3
9
Tab
Battery
Cover
Batteries
32
16
2
7
Fig. 1a
Foot
Round
Tube
Fig. 1b
6
6
5
5
Stop
1
1
Back
Front
Hold
Here