Filter
Top Products
11. At the same time, insert a Pedal Arm Axle (21)
into the Right Upper Body Leg (31) and into the
right Pedal Arm (14); make sure that the
Upper Body Leg Spacer (113) and the Pedal
Leg Spacer (114) are in the indicated loca-
tions.
Attach the Right Upper Body Leg (31) with an
M6 x 16mm Patch Screw (80) and an M6 Large
Washer (90).
Then, attach the right Pedal Arm (14) with an
M6 x 16mm Patch Screw (80) and an M6 Large
Washer (90).
Repeat this step for the other side of the
elliptical exerciser.
See step 3. Tighten the four M10 x 20mm
Patch Screws (79). Tip: Tighten the two Patch
Screws on the front of the elliptical exercis-
er before tightening the other two Patch
Screws.
11
14
114
113
21
12. Identify the Right Upper Body Arm (9), which is
marked with a "Right" sticker. Orient the Right
Upper Body Arm as shown; make sure that
the hexagonal holes in the Right Upper
Body Arm are in the indicated location.
Slide the Right Upper Body Arm (9) onto the
Right Upper Body Leg (31). Attach the Right
Upper Body Arm with two M6 x 38mm Button
Bolts (76) and two M6 Locknuts (77); make
sure that the Locknuts are inside the hexag-
onal holes.
Repeat this step for the Left Upper Body
Arm (8) and the Left Upper Body Leg (6).
12
onal
Holes
13. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be
left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical exerciser.
11