Filter
Top Products
ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver and rubber mallet .
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
2. With the help of a second person, carefully lower the
treadmill frame and then tip the Uprights (69) down as
shown. Make sure that the Extension Legs (102) remain
in the Uprights.
Attach each Extension Leg (102) with two 3/4Ó Screws
(100) as shown.
With the help of a second person, carefully tip the
Uprights (69) back to the vertical position.
Note: One replacement Base Pad (99) may be included.
Use the extra Pad if one becomes worn or needs to be re-
placed.
100
102
69
99
99
Frame
69
100
102
1. With the help of a second person, carefully raise the
treadmill to the upright position.
While a second person tips the treadmill to one side
and holds it, insert one of the Extension Legs (102) into
the treadmill as shown. Make sure that the Extension
Leg is turned so the Base Pad (99) is on the bottom.
Next, tip the treadmill to the other side and insert the
other Extension Leg (not shown) in the same way. Lower
the side of the treadmill so that both Extension Legs
(102) are resting flat on the floor.
102
99
1
2
3. Using the included allen wrench, tighten the Pulse Bar
Bolt (78) on each side of the treadmill.
Find the plastic tie inside the post on the right Upright (69).
Insert the plastic tie through a Handrail Extension (66) and
insert the Handrail Extension into the post as shown. Make
sure that the indicated holes are on top. Tap the Handrail
Extension with a rubber mallet to fully insert it. Attach the
Handrail Extension with two 1/2Ó Screws (67) as shown.
Identify the Right Foam Grip (75), which has a cutout in the
left side for the Pulse Bar (76). Slide the Right Foam Grip as
far as possible onto the post on the right Upright (69).
75
76
Cutout
Tie
66
Post
67
Holes
69
78
3
6