Filter
Top Products
9
6. Identify the Left and Right Handrails (59, 64),
which are marked “Left” and “Right.” Remove the
four 5/16" x 3/4" Screws (5) and four 5/16" Star
Washers (6) from the bottoms and sides of each
Handrail.
Hold the Right Handrail (64) near the Right
Upright (76). Insert the wire tie on the Upright
Wire (63) through the hole in the bottom and
out of the hole in the side of the Left Handrail as
shown. Then, pull the Upright Wire through the
Right Handrail.
Attach the Right Handrail (64) to the Right
Upright (76) with two of the 5/16" x 3/4" Screws
(5) and two of the 3/8" Star Washers (6) that
you just removed. Make sure not to pinch the
Upright Wire (63). Start both Screws, and
then tighten them.
Attach the Left Handrail (59) to the Left Upright
(66) as described above. Note: There are no
wires on the left side.
6
6
5
5
5
5
6
6
6 59
66
76
64
5, 6
5, 6
63
7
64
6
5
5
5
6
6
61
47
59
7. Position the Console Crossbar (61) between
the Left and Right Handrails (59, 64) with
the Console Ground Wire (47) positioned as
shown.
Attach the Console Crossbar (61) to the Left
and Right Handrails (59, 64) with the other four
5/16" x 3/4" Screws (5) and the other four 5/16"
Star Washers (6) that you removed in step 6.
Start all four Screws, and then tighten them.