Filter
Top Products
7
2
. Attach a Wheel (66) to the base of the Uprights (69) with
a Wheel Bolt (64) and a Nut (13) as shown. Do not
overtighten the Bolt; the Wheel should turn freely.
W
ith the help of a second person, carefully tip the tread-
mill onto its other side. See assembly step 1, and attach
the other Extension Leg (63) and the remaining two
Base Pads (57). Then, attach the other Wheel (66) as
d
escribed above.
With the help of a second person, carefully lower the
base of the Uprights (69) to the floor so the Uprights are
in a vertical position.
6
6
1
3
69
64
3. If there is a board between the Uprights (69), remove the
board and the two bolts. Discard the board and the bolts.
Identify the Right Handrail (72), which has a large hole in
the left side. Remove the wire tie securing the Upright
Wire (42) inside of the right Upright (69). Feed the
Upright Wire into the hole in the bottom of the Right
Handrail and out of the large hole in the side. Note: It
may be helpful to use needlenose pliers to pull the Wire
Harness out of the hole.
Set the Right Handrail (72) on the right Upright (69).
Attach the Right Handrail with two Handrail Bolts (37)
and two Handrail Star Washers (95). Be careful not to
pinch the Upright Wire (42).
Attach the Left Handrail (71) as described above. Note:
There is not an upright wire on the left side.
42
Hole
72
95
95
37
37
95
71
69
69
2
3
Small
Hole
71
4. Hold the Console Base (47) near the Left Handrail (71).
Attach the end of the ground wire on the Console Base
to the indicated small hole in the Left Handrail with the
Silver Ground Screw (75).
47
75
Ground
Wire
4